Don’t be left in the dark. This leather holster keeps your flashlight handy.
Editor’s Note: This holster is designed for a belt 1 1/4″ to 1 1/2″ wide.
WHAT YOU’LL NEED
WHAT YOU’LL DO
Step 1: Place the best-looking side of the leather down and draw the holster and belt loop. For the length of the holster, measure around your flashlight and add 1 1/4”.
Step 2: Mark the holes on the belt loop and holster.
Step 3: Find the center of the holster length and mark off 1/4” segments as shown.
Step 4: Cut out the belt loop and holster.
Step 5: Punch out all six holes.
Step 6: Roll the holster, align the holes and push the rivet through from the inside.
Step 7: Slide the bottom end of the belt loop over the rivet and cap.
Step 8: Align bottom loop holes, push the rivet through from inside, and cap and hammer securely.
Nowadays, you can get mini-maglights that come with a belt-holster for less than the waste of time for this project. At any rate, cute little project (if you’re bored)!
ok
i don’t have any leather
Next time you go to hobby lobby, or any craft store, they should have it there.
neat! hope my flash light won’t fall out the top.
cool
It works
I’ll use this on my Philmont Trek this summer!
i hope that could also hold nerf pistols
You probably could if you change the shape a bit
cool